Classic Beaumont Masonry and Concrete

Masonry Contractor in Banning, CA - Square, Level Walls and Careful Brick Repair

Classic Beaumont Masonry and Concrete is a masonry contractor in Beaumont, CA that builds block, brick and retaining walls, repairs cracked brick and mortar, and lays walkways and pavers for homeowners in Banning.

Red brick wall meets a grid of blue-gray glass blocks above a narrow masonry ledge.

Banning houses run from older brick to new tracts

Banning is a short drive from us in Beaumont, and the houses there look a lot like ours. In the older parts of town we find brick chimneys, planters and block walls that have been standing a long time, and newer homes keep going up as the city grows. We do the same kinds of jobs here that we do in Beaumont and Cherry Valley, so most calls from Banning are familiar ones, like cracked joints, a garden wall starting to lean or a new wall along a property line.

A lot of Banning lots aren't flat, so yards get stepped with low walls and the back fence often sits on block that's holding back dirt. On ground like that, the footing and where the water goes decide how long a wall stays straight, which is why I spend more time on those than on the face you'll look at.

What we know from working in Banning

Permits for construction in Banning come from the city's Building and Safety Division, and its list of work that needs one includes structural repairs and walls, so a good share of our jobs here start with an application. The city's review has to clear before our crew can start, and that's usually what the start date turns on, more than our calendar. We're fully licensed and insured, and when a job needs a permit we prepare the application, send it to the city and work through the inspections it calls for.

What moves the price here is mostly the wall itself, how tall and long it runs, whether it holds back a slope and needs an engineer's design, and how deep the footing has to go. Access counts too, because a narrow side yard means carrying block in by hand. On repair work, the price turns on how much old mortar has to come out, and I can't tell you that for sure until we open a few joints. It's the same way we look at jobs in Calimesa, and I'll walk you through each of these when I come out.

Our masonry work in Banning

Older brick and sloped yards keep us busy here

The older brick around Banning usually fails at the joints first, because mortar is meant to wear before the brick does, and once it's cracked or sandy, water gets in behind it. We cut out the bad joints and pack in a mortar suited to the old brick, since a mix that's too hard can crack the brick faces around it, and our brick repair page goes into how we do it. If your joints are tired but still holding, I'll tell you the work can wait.

Sloped lots bring the rest of our calls here, mostly retaining walls and the block walls that sit on top of them. A city staff report on Banning's code update says the grading rules were changed to bar draining water across onto a neighbor's lot and to require plans from licensed engineers and certified designers, so we work out where a wall's water goes before we dig.

Get a free estimate for your Banning wall or brick work

We reply within one business day, by phone or by message. I'll come out to Banning, look at the job with you and give you a free on-site estimate, with no obligation to go ahead.

(951) 524-1277

How a masonry job goes when you call us from Banning

  1. Call or send us a message

    Call (951) 524-1277 or use the contact form and tell us what you're seeing, whether it's cracked joints, a leaning wall or a new wall you want built. A couple of photos help me know what to look for.

  2. I look at it with you

    I come out to Banning myself, walk the job with you and give you my estimate on site. I'll explain what I'd do and why, and tell you if something can wait.

  3. We file the permit if needed

    If the job needs a permit, we prepare the application and file it with the city, and you sign the owner permission it asks for. The city's review has to clear before we start, so its timing sets our start date.

  4. Our crew does the work

    Our crew of trained masons sets the footing, lays the wall to a line and meets the inspector for any inspection the permit calls for. Clearing a path along the work area before we arrive helps us get started.

  5. I check it before we're done

    I check the wall for square, level and clean joints before we call it done. Then we clean up and walk the finished job with you.

Banning masonry questions we hear

Do I need a permit to build a block wall in Banning, CA?

Yes, if it's over 2 feet tall, because the city's permit handout requires permits for block walls and retaining walls over 2 feet. Any retaining wall that holds back a slope needs a permit and an engineered design whatever its height, and the handout says every wall needs planning approval. We sort out which of these applies to your wall before we start.

How much does a block wall or retaining wall cost in Banning?

The price comes down mainly to the wall's size, the ground it sits on and the material, so I give you a figure only after I've seen your yard. Brick, stone veneer or a decorative cap costs more than plain block, and a wall that needs an engineered design costs more than a short garden wall on flat ground. If budget matters, I'll show you where a simpler finish saves money without cutting corners underneath.

Which building code applies to a permit application in Banning right now?

Any application you file now goes under the 2025 California building codes, which took effect in Banning on January 1, 2026, along with the city's own changes. Applications received on or after that date, or not yet complete by then, follow the new code. When we handle your permit, we prepare the application to the current code, so you don't have to track it.

How do I apply for a building permit in Banning?

You set up an online account with the building office and submit your application through it, and staff can help you at the computer kiosks at City Hall. Every residential application needs the owner's signed permission. When we handle the permit, we prepare and file it, and you sign as the owner.

How do I get a DigAlert ticket before digging in Banning?

You get a DigAlert ticket by calling 811 or going online at www.digalert.org, and the city asks for one before anyone digs. The ticket gets buried lines marked so a shovel doesn't find them first. On our jobs, we call for the ticket before our crew digs a footing.

Do I need a permit for an outdoor kitchen or a walkway in Banning?

The city's handout doesn't name either one, and it says it isn't a complete list, so the way to know is to ask the building office at buildingandsafety@banningca.gov. That's the address the city gives for work the list leaves out. If you'd rather not chase it, we'll check with them for you before any work starts.

Where we work

Book a visit for your Banning wall or brick

We pick up evenings and weekends, so call (951) 524-1277 or send the contact form whenever it suits you.

Request an estimate(951) 524-1277
(951) 524-1277Request an estimate